JL Audio Car Stereo System
Take out the hassle by letting one of our highly trained technicians install your JL Audio Car Stereo System for you.
Please note : Additional fitting components are usually required subject to the make and model of your vehicle which we can quote you for prior to the installation.
Contact us on 01924 201884 or email to book your appointment.
The JX400/4D Amplifier employs a highly-efficient Class D design with a robust MOSFET power supply to deliver a strong 100 watts to each of its four channels into 2 ohms (14.4V, 1% THD).
The JX400/4D includes a defeatable 12 dB / octave filter for each channel bank, which can be configured as a low-pass or high-pass filter and offers continuously variable cutoff frequency selection from 50-200 Hz. Dedicated hi-level inputs are included, in addition to conventional low-level RCA inputs, making it easy to integrate with a variety of OEM and aftermarket head units.
C1 speakers deliver real substance and great audio performance in a format designed for easy fit behind factory grilles.
To facilitate fit, multi-application adaptor rings are included for the C1-650 woofers, allowing easy, drop-in installation in vehicles equipped with oversized 6.5-inch and 6.75-inch speaker openings. Without the ring, the woofers will also fit into many "6-inch" speaker locations as well. Surface and flush mounts are included with C1 tweeters for maximum installation versatility
Enclosed Car Subwoofer System with Single 10WXv2-4 Subwoofer Driver, Dark Gray Carpet (200 W, 4 Ω) - Sealed Enclosure
This compact BassWedge™ subwoofer system delivers great-sounding sub-bass at an unsurpassed value.
This subwoofer system is shipped wired, loaded and ready to connect via a push-button terminal.
Finish: Dark gray, high-grade automotive carpet with "JL AUDIO" embroidery on the top surface.
Recommended amplifier power: 75 - 200W
Nominal Impedance: 4 Ω
|Frequency Response 20 Hz - 20 kHz (+0, -1dB)|
|S/N Ratio, referred to highest rated power >93 dB below rated power (A-weighted, 20 Hz - 20 kHz noise bandwidth)|
|S/N Ratio, referred to 1 W >76 dB (A-weighted, 20 Hz - 20 kHz noise bandwidth)|
|Damping Factor @ 4 &||937; >60 / 50 Hz|
|Damping Factor @ 2 &||937; >30 / 50 Hz|
|THD+N @ Rated Power <1% @ 2 &||937; per Ch.|
|Input Voltage Range @ RCA Inputs 200 mV - 4 V RMS|
|Input Voltage Range @ High-Level Inputs 2 V - 10 V RMS|
|Min.Copper Power / Ground Wire Gauge 4 AWG wire|
|Fuse Rating 40 A (AFS, AGU or MaxiFuse™)|
|Filter Mode(s) Low-Pass or High-Pass|
|Filter Slope(s) 12 dB/octave|
|Filter Frequency Range 50 Hz - 200 Hz|
|Detented, Calibrated Filter Freq. Potentiometers No|
|Filter Defeat Function Yes|
|Remote Level Control No|
|Remote Level Modes N/A|
|Channel Input Mode Switch Yes (2/4 ch.)|
|Pass-Through Preamp Output Unbuffered|
|Source Channel Selection for PreOuts No (always 2 Ch)|